Defrosting Of The Freezer - AEG S52700DSW1 Benutzerhandbuch

5.2 Automatic defrosting of the fridge

5.3 Defrosting of the freezer

There can be frost on the freezer
shelves and around the top com-
partment.
Defrost the freezer when the lay-
er of frost has a thickness of 3 or
5 mm.
CAUTION!
Do not use sharp metal tools to
remove the frost.
Do not use mechanical devices
to defrost the freezer.
1. Deactivate the appliance.
2. Remove all the food from the freezer.
Wrap the food in newspaper and
keep it at a cold temperature.
3. Keep the appliance door open until
defrosting is completed.
4. Clean and fully dry the freezer.
5. Connect the mains plug to the mains
socket.
The removal of frost occurs automatically
when the motor compressor stops dur-
ing operation.
The water drains out through the drain
hole and collects in the water container
where it evaporates.
The water container is behind the appli-
ance, above the motor compressor.
The drain hole is in the fridge on the rear
part.
To prevent water to collect in other parts
of the fridge, make sure that the drain
hole is always clean. Use the cleaning
tool that is in the drain hole.
6. Activate the appliance.
7. Set the temperature knob at the
highest position and let the appli-
ance operate for 2 or 3 hours with
this setting.
8. Put back the food in the freezer.
5.4 When the appliance is not
used for long periods
1. Deactivate the appliance and discon-
nect the mains plug from the mains
socket.
2. Remove all the food.
3. Defrost the appliance.
4. Fully clean and dry the appliance and
all the accessories.
5. Keep the doors open to prevent un-
pleasant smells.
ENGLISH
19