Brake Adjustment - REma KA Serie Gebrauchsanleitung

Brake Adjustment

As air hoist operaties (as compressed air is supplied);
Brake cam(4) connected with the control valve of valve case rotates and pushes the brake
adjust plate(3). It causes the brake pad(7) disconnect the brake wheel(8). And air hoist
will operate.
As Air hoist stops (as compressed air stops);
The control vaves lever will be in neutral position and the brake cam(4) returns to its own
location. And then, the brake pad(7) and the brake wheel(8) wil be contracted. As a
result, air hoist will stop. Under a rated loads, the brake does not have any slip in
accordance with the brake adjustment.
A C C E S S O R Y N A M E
N O N A M E
1 B rake A dj ust B ol t
2 B rake S etti ng N ut
3 B rake A dj ust P l ate
4 B rake C am
① Loose the brake setting bolt (1) and the
Brake Setting Nut(2).
② Loose the brake adjust fixing nut(6).
③ Make sure the brake adjustment plate(3) to
contact the brake shoe(5).
④ Tighten the brake setting bolt(1) and the
nut(2).
⑤ Adjust the clearance between the brake
adjustment plate(3) and the brake cam(4)
of 0.5~1mm as shown.
⑥ Make sure the brake pad(7) and the brake
wheel evenly and completely contacted.
⑦ Tighten the brake adjustment fixing nut,
after checks.
Note : Tighten the nut after fixing
the brake adjustment plate.
14
N O N A M E
5 B rake S hoe
6 B rake A dj ust R ock N ut
7 B rake P ad
8 B rake W heel