Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Safety instructions before completing installation
Air chain hoists are only intended for lifting and moving loads and may be used as stationary or
traveling units. Air chain hoists may only be operated when in perfect working order by trained personnel
in accordance with the relevant safety and accident prevention regulations. This also includes compliance
with operating and maintenance conditions specified in the operating instructions.
Any failure to comply with the safety instructions stated in these operating instructions can result in death
or personal injury. Observe general statutory and other bligatory regulations relating to accident
prevention and environmental protection and basic health and safety requirements in addition to those
included in these operating instructions. Such requirements my relate, for example, to the handling of
hazardous materials or the provision/wearing of personal protection equipment. We assume no liability for
damage and malfunctions resulting from failure to comply with the operating instructions.
1.1 General safety instructions
- All instructions and measures described in the operating instructions with regard to safe
operation and items concerning general safety and accident prevention which have to be
observed before, during and after putting into service must be strictly complied with.
- Never use the air hoist for lifting or lowering people, and never allow anyone to stand on
a suspended load.
- Safe operating instructions are provided to make all operators aware of dangerous
practices to avoid and are not necessarily limited to the following list.
- Comply with these regulations and general accident prevention regulations relevant for
the place at which the air chain hoist is used and follow the instructions therein when
working with the air chain hoist.
1.2 Air supply and lubrication
- The required operating air pressure is 620kPa(6.2kg/㎠) for the satisfactory efficiency at
the specified maximum lift speed. If necessary, the regulator should be installed.
- Air filter and Lubricator should be provided at the nearest location of air inlet.
- Under normal operation conditions, the oil must be checked periodically. Under
exceptional conditions, e.g. increased ambient temperatures, we recommend that oil
changes be adapted to suit these conditions.
- The quantity of flushing oil used should be checked periodically.
- The distances between FRL and air hoist should be kept within 5m.
1.3 Safety instructions for operators
- Do not exceed the maximum permitted load and permitted load dimensions.
- Do not leave suspended loads unsupervised.
- Do not allow the chain to run over edges.
2. Specifications
Model
KA1S-025
KA1S-050
KA1S-100
KA2S-100
KA1S-200
Rated load
Air pressure
[kg]
[bar]
250
6
500
6
1000
6
1000
6
2000
6
Lifting speed
Air consumption
[m/min]
[ltr/sec]
18
12
6
6,5
3,2
11
Air inlet
[mm]
27
12
27
12
27
12
30
20
30
20
Werbung
Inhaltsverzeichnis
