Operator Alerts - Jacobsen LF 3400 Betriebs- Und Sicherheitshandbuch

3 CONTROLS
3.4

OPERATOR ALERTS_______________________________________________________

The electronic controller monitors vital machine systems. It
uses an audible alarm and warning lights to alert the
operator of conditions requiring immediate action. When an
alert occurs follow the general guidelines listed in the chart
below, and any specific actions outlined by the grounds
superintendent or service manager.
To test alarm system:
Turn ignition switch to RUN. All lights will come on for one
second or more and the alarm will sound briefly.
This system monitors:
1. Hydraulic fluid level
2. Engine oil pressure
3. Engine coolant temperature
4. Hydraulic oil filter
5. Battery voltage
6. Dual activation of brake and traction pedal.
Alert
1. Hydraulic fluid level - alarm
sounds and hydraulic fluid warning
light comes on. Hydraulic fluid is
below recommended level.
2. Engine Oil Pressure - alarm
sounds and oil pressure
comes on. Oil pressure low.
3. Engine Coolant
Alarm sounds. Engine
temperature high.
4. Hydraulic oil filter - Oil filter
warning light remains on.
5. Battery Voltage - Warning light
comes on.
6. Driving with brake on - Alarm
Sounds
GB-12
Stop tractor immediately, lower implements and shut off engine! Visually
inspect tractor for obvious signs of leaks around connections, hoses and
hydraulic components. Return tractor to service area for maintenance.
CAUTION: Hydraulic fluid is under pressure. Turn engine off and allow fluid
!
to cool before checking fluid level or adding oil to hydraulic tank.
Stop tractor immediately, lower implements and shut off engine! Inspect oil
light level in engine. If oil light remains on with oil at proper level, shut off engine and
tow or trailer tractor back to a service area. NEVER operate engine with oil light
on, severe damage to the engine can occur.
Stop tractor immediately, lower implements and shut off engine! Remove
Temperature
coolant debris such as leaves and grass clippings that may be restricting air flow through
rear screen on hood and area between radiator and oil cooler. If engine continues
to run hot, return tractor to a service area.
CAUTION: Engine coolant is under pressure. Turn engine off and allow
!
fluid to cool before checking fluid level or adding coolant to radiator.
Return tractor to a service area as soon as possible. Change hydraulic oil
filters.
Return tractor to a service area as soon as possible. Inspect battery and
battery charging system.
Disengage parking brake, or remove foot pressure from either pedal.
Continued operation with both brake and traction pedal depressed will cause
engine to stop in 10 - 60 seconds, depending on the order of pedal application.
3
1
5
Action
2
4
LF004
Figure 3C