Fujitsu CELSIUS J series Gebrauchsanweisung Seite 20

4 – English
Table 2: Guidance and manufacturer's declaration –
The EUT Name is intended for use in the electromagnetic environment specified below. The
customer or the user of the EUT Name should assure that it is used in such an environment.
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
inter-ruptions and
voltage variations
on power supply
input lines
IEC 61000-4-11
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
Note UT is the AC mains voltage prior to application of the test level.
14
electromagnetic immunity
IEC 60601 Compliance
test level level
+/- 6 kV contact +/- 6 kV
+/- 8 kV air +/- 8 kV
+/- 2 kV for power +/- 2 kV
supply lines
+/- 1 kV for +/- 1 kV
input/output lines
+/- 1 kV +/- 1 kV
differential mode
+/- 2 kV common +/- 2 kV
mode
<5% UT passed
(>95% dip in UT)
for 0.5 cycle
<40% UT passed
(>60% dip in UT)
for 5 cycles
<70% UT passed
(>30% dip in UT)
for 25 cycles
<5% UT passed
(>95% dip in UT)
for 5 sec
3 A/m 3 A/m
CELSIUS (Med) / ESPRIMO (Med)
Electromagnetic environment -
guidance
Floors should be wood concrete or
ceramic tile. If floors are covered with
synthetic material the relative humidity
should be at least 30%.
Mains power quality should be that of a
typical commercial or hospital
environment.
Mains power quality should be that of a
typical commercial or hospital
environment.
Mains power quality should be that of a
typical commercial or hospital
environment. If the user of the EUT Name
requires continued operation during
power mains interruptions, it is
recommended that the EUT Name be
powered by an uninterruptible power
supply or a battery.
Limited to the voltage power range from
200 V to 240 V / 50 / 60 Hz
Power frequency magnetic fields should
be at levels characteristic of a typical
location in a typical commercial or
hospital environment.
Fujitsu