Medel MYO TENS Handbuch Seite 51

Tab. 4) Recommended separation distances between portable and mobile RF communications equipment
The Medel Smart is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled.
The customer or the user of the Device can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and the Device as recommended below, according
Rated maximum output power of
transmitter W
0,01
0,1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated using the equation applicable to
the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.
100275_MYO-TENS_USER MANUAL_REV.00.indd 51
and the Medel Smart
to the maximum output power of the communications equipment.
Separation distance according to frequency of transmitter m
150 kHz to 80 MHz (out ISM 150 kHz to 80 MHz (in ISM and
and amateur radio bands)
d=1.2√p
0.12
0.38
1.2
3.8
12
80MHz to
amateur radio bands) 800MHz
d=2√p d=1.2√p
0.2 0.12
0.632 0.38
2 1.2
6.32 3.8
20 12
51
EN
800MHz to 2.7GHz
d=2.3√p
0.23
0.73
2.3
7.3
23
08/08/2019 15:15:03