Davey StarFlo DSF200CE Installation Und Betriebsanleitung Seite 9

Removal of the Pump from Pipework
Should it be necessary to remove the pump, follow these instructions:
1. Turn off the power and remove the plug from the power source.
2. Close the water valves on the pool return and the pump inlet pipework.
3. Remove the discharge & suction barrel unions taking care not to lose the O-rings.
4. Move the pipework with the barrel unions attached until the pump can be pulled clear.
NOTE: When making any enquiries about your StarFlo pool pump be
certain to quote the model number from the nameplate located on motor.
Water Quality
Maintaining balanced water chemistry is important to the life of your pool pump. This pump is
designed to be used with Pool water, balanced in accordance with Langlier Saturation Index,
with a pH level of between 7.2 and 7.8 and is regularly treated with a chlorine sanitising
agent with the level not exceeding 3.0 PPM.
Please consult your local pool shop regularly to have your water tested.
POWER CONNECTIONS AND WIRING MUST BE CARRIED OUT BY
AN AUTHORISED ELECTRICIAN.
WARNING! Pump suction is hazardous and can trap and drown or
disembowel bathers. Do not block suction. Do not use or operate
swimming pools if a suction cover is broken, missing or loose. Two
suction covers and inlets must be provided into every pump to avoid
suction entrapment.
Caution! Do not add chemicals directly to the pool skimmer. Adding
undiluted chemicals may damage pump and filter and void warranty.
9