Power Connection - Davey StarFlo DSF200CE Installation Und Betriebsanleitung

Power Connection

IMPORTANT INFORMATION: Your Davey pump is Double Insulated to Water Circuit. If
equipotential bonding structure is required, then a Equipotential Bonding Point is provided.
(Please refer to your local wiring standard and regulations).
Davey StarFlo pool pumps are suitable for connection to a nominal 220-240 volt 50Hz
power supply and are equipped with a flex lead. If a power outlet is not available within
3 metres of the pump, a power point in a safe, dry place may need to be provided by
an electrician. Extension cords are unsafe around pools – and should be avoided. If the
supply cord of this product is damaged it must be replaced by the Dealer or distributor,
with genuine Davey spares.
Davey Water Products recommends that all installations are fitted with
earth leakage or residual current protection devices.
CAUTION: In the interest of safety, we advise that all brands and types of pool
pumps must be installed in accordance with AS3000 or refer to your local
wiring rules or equivalent.
In accordance with AS/NZS 60335.2.41 or EN60335.2.41 we are obliged to
inform you that this pump is not to be used by children or infirm persons
and must not be used as a toy by children.
Power supply to this pump needs to be through an isolating transformer
or RCD, having a rated operating current not exceeding 30mA.
If the pump and filter are located below pool water level, it is necessary to
fit isolating valves in the pipe between the pump and the skimmer box and
in the return pipe between the pump and the filter.
The fittings on this product are constructed of ABS. Some PVC jointing
compounds are incompatible with ABS. Check compound suitability
before use.
CAUTION: In order to avoid a hazard due to inadverdant resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
WARNING! Ensure that an electrical isolation switch is located with easy
access so that the pump can be turned off in an emergency.
4