Install Pcset Graphic Software; Recognising And Removing Interferences - Reiner jetStamp graphic 970 Kurzanleitung

jetStamp graphic 970
Gently push the lock of print cartridge
f
can be opened.
Open print cartridge flap
f
Take new print cartridge
f
15
nozzles .
Put the jetStamp graphic 970 on a fixed flat surface.
f
Insert printing cartridge
f
Close the print cartridge flap
f
Push the trigger button
f

1.3. Install PCset graphic Software

Installation is only possible with administrator rights on the computer.
Insert PCset graphic USB memory stick into the drive.
f
If the installation programme does not start up automatically, start the file "setup.exe".
f
Observe the installation programme instructions.
f
1.4. Firmware update
The most up to date firmware for the jetStamp graphic 970 can be downloaded from the
REINER website (www.reiner.de).

1.5. Recognising and Removing Interferences

For more information, see the online help of the PCset graphic software, or the enclosed USB
memory stick.
All rights reserved. Translation, reprint and other reproduction of these operating
instructions, even in parts and no matter the form, shall require our express written consent.
We reserve the right to make content changes to these operating instructions without notice.
13
to the right, until the print cartridge flap
11
.
12
from the packaging and remove protective film from the
12
.
11
.
1 3
. Print carriage moves to the home position.
11
GB
10