Operation - ION Octave LP Schnellstartanleitung

Operation

CD Mode
Standard audio and data CDs, CD-Rs, and CD-RWs can be used. If you are using a data CD,
make sure it contains MP3 files. The unit cannot play other files.
Note: If a CD contains more than 999 files in a folder, the files above 999 will not appear
correctly on the display. Arrange your files into folders with a maximum of 999 files per folder.
Loading and Unloading a CD
1. Press the Source button to select CD Mode.
2.
Open the CD Tray by pressing the Eject button.
3.
When the CD tray has opened, carefully place the CD in the tray with the label facing up.
Position smaller discs in the center of the CD tray.
4.
Close the CD tray. The total number of tracks on the CD will appear on the display and
the CD will play automatically.
Repeat/Random Playback
To change the playback mode, press the Play Mode button. It will cycle through the
following modes:
•
Repeat (One): The current track is repeated. When active, the Repeat symbol (
appear in the display.
•
Repeat Folder: All tracks in the current folder are repeated. When active, Folder will
appear next to the Repeat symbol.
Note: This mode is only available when using MP3 discs.
•
Repeat All: All tracks are repeated. When active, All will appear next to the Repeat
symbol.
•
Random (RDM): All tracks are rearranged into a random sequence for playback.
•
Off: Normal operation.
Programming CD Track Playback Order
Follow these instructions to program the playback order for tracks on a CD.
Note: The CD playback must be stopped before programming track order.
1. While stopped, press the Program button on the remote control or the Play Mode button
on the front panel.
2. Press the Previous or Next buttons to select the location in which the track should be
stored, i.e. track 03.
3. Press the Program button again. The first programmed selection is now stored in the
programmed memory.
4. Repeat Steps 2 and 3 to add more tracks to the program.
5. To listen to the programmed tracks, press the Play/Pause button. The CD will start
playing at the beginning of the first programmed track.
6. To clear the programmed memory, press the Stop button twice while the disc is playing.
) will
7