Operation - ION Treble LP Schnellstartanleitung

Operation

Pairing Treble LP to a Bluetooth Speaker
Treble LP has a Bluetooth transmitter to send audio to a Bluetooth speaker wirelessly.
1. Power on your Bluetooth speaker and ensure it is in pairing mode.
2. Power on the Treble LP turntable. Wait five seconds for it to be ready for Bluetooth
Pairing.
3. Press and release the Bluetooth button on Treble LP to start pairing to your Bluetooth
device. Once Treble LP is connected to the Bluetooth speaker, the Bluetooth LED will be
solid blue. Your Bluetooth speaker should also indicate that its paired.
Note: Treble LP will connect to the closest Bluetooth speaker that is near it. If after 5
minutes no Bluetooth speaker can be found to pair with, the Bluetooth transmitter will
become inactive and the LED will turn off.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0 or higher.
4. Play music on your Treble LP turntable. If you are connected to a Bluetooth speaker with
a play/pause button, and do not hear audio, try pressing the play/pause button.
5. Adjust the volume on your Bluetooth speaker (if applicable) or the Volume knob on Treble
LP to control the output level.
6. To disconnect pairing, power off the Treble LP turntable, turn off Bluetooth pairing on
your Bluetooth speaker, or press the Bluetooth button on the Treble LP.
Note: Move other Bluetooth receivers/speakers out of range of Treble LP (30'/9.1m or more)
or turn them off to connect to your Bluetooth speaker.
Playing a Record
1. Loosen and remove the plastic cap from the turntable's platter by turning it clockwise.
2. Place your record on the turntable.
3. Place the plastic cap back on the turntable's platter by screwing it counterclockwise,
tightening it to secure the record in place.
4. Power on the unit and select the proper playback speed by turning the Power / 33/45
switch.
5. Remove the arm clip holding the tonearm in place, and place the tonearm on the record.
6. Adjust the volume as desired using the Volume knob.
6