ION Octave LP Schnellstartanleitung Seite 10

Saving and Recalling Presets
To save a preset:
1. While tuned to the desired station, press and hold the Preset button for 2 seconds.
2. Turn the Tuning/Enter knob to choose which Preset slot the station will be saved to.
Preset slots that have not been used will appear as "(Empty)" in the display.
3. Press the Tuning/Enter knob to save the station to the preset slot. "Stored" will appear in
the display.
4. Repeat these steps to add up to 10 of your favorite stations as presets.
To recall a preset:
1. Briefly press the Preset button.
2. Turn the Tuning/Enter knob to select which preset you would like to load.
3. Press the Tuning/Enter knob to load the preset.
Note: The process for saving and recalling presets is the same for FM Mode.
FM Mode
1. For best results, extend the FM Antenna on the rear panel.
2. Press the Source button to select FM Mode.
3. Use the Tuning knob to manually select a station, or press the Scan button to jump to the
next station depending on the Scan Setting. To change the direction of the Scan, press
the Previous or Next buttons. Scan will now search in that direction.
4. If you tune to a stereo FM station, the Stereo indicator will appear in the display. If you
tune to an FM station with a weaker signal, the reception will automatically switch to
Mono.
5. When you have selected a station, you can press the Info button to view the following
information in the display: Program Name, Program Type, Program Number, Audio
Setting, Time, and Date.
6. While in FM Mode, press the Menu button to access the following options:
•
Scan Setting: Select All Stations to scan the entire FM range or Strong Stations
Only to scan for stations with a strong signal.
•
Audio Setting: Select Stereo Allowed for stereo playback when available or
Forced Mono to limit all stations to mono. You can also press the Tuning knob to
switch between stereo and mono.
•
System: See
Bluetooth Mode
1. Press the Source button to select BT Mode.
2. The display will flash BT Disconnected. When pairing, remain within 10 meters (33 feet)
of Octave LP.
3. Turn on Bluetooth on your phone or tablet to pair. Select Octave LP as the Bluetooth
device.
Note: If your Bluetooth device prompts for a pairing code, enter "0000".
4. When successfully paired and connected, the display will show BT Connected.
5. To disconnect from the currently paired Bluetooth device and pair to another Bluetooth
device, hold the Stop button for 2 seconds.
10
System Settings for more information.