Setting The Table Square With The Blade - GMC DB250SMS Anleitung

Setting the table square with the blade

1. Make sure that the electrical plug is removed from
the power point.
2. Push the saw arm (5) down to its lowest position and
engage the release knob (6) to hold the saw arm in the
transport position.
3. Loosen the mitre lock (25)
(Fig. U).
GB
4. Rotate the table (21)
until the pointer is
positioned at 0º.
5. Tighten the mitre lock (25).
6. Loosen the bevel lock (16)
and set the saw arm (5) at
0º bevel (the blade at 90º to
the mitre table). Tighten the
bevel lock (16) (Fig. V).
V
7. Place a set square against
the table (21) and the flat part of the blade. (Fig. W)
Note. Make sure that the square contacts the flat part of
the saw blade, not the teeth.
8. Rotate the blade by hand and check the blade-to-table
alignment at several points.
9. The edge of the set square and the saw blade should
be parallel.
10. If the saw blade angles away from the set square,
adjust as follows.
11. Use a 13mm wrench or adjustable wrench to loosen the
U
W
lock nut securing the 0°
bevel adjustment screw
(35) (Fig. X). Also, loosen
the bevel lock (16).
12. Adjust the 0° bevel
adjustment screw (35)
with the 6mm hex key to
bring the saw blade into
alignment with the square
(Fig. Y).
Y
13. Loosen the 2 Phillips head screws holding the pointer
of the bevel scale (17) and adjust the position of the
pointer so that it accurately indicates zero on the scale
(Fig. Z). Retighten the screw.
14. Retighten the bevel lock (16) and the lock nut securing
the 0° bevel adjustment screw (35).
Note. The above procedure can also be used to check the
angle of the saw blade to the table at either 45º bevel angle
to the left or to the right. The 45° bevel adjustment screws
(33 & 34) are on opposite sides of the saw arm. You will
a
12
X
Z
b