Mitre Table Lock; Bevel Lock; Bevel Adjuster; Clamp Assembly - GMC DB250SMS Anleitung

Mitre table lock

The mitre table lock (25) is
used to lock the table at the
desired mitre angle (Fig. F).
The mitre saw cuts from 0°
to 45° both left and right. To
adjust the mitre angle loosen
the mitre table lock and using
GB
the mitre table handle adjust
the mitre angle to the desired
position. The mitre table
features positive click stops at 0°, 15°, 22.5°, 30° and 45°
for quick setting of common mitre angles.
WARNING. Be sure to tighten the mitre table lock before
making a cut. Failure to do so could result in the table
moving during the cut and cause serious personal injury.

Bevel lock

The bevel lock (16) is used to
set the blade at the desired
bevel angle (Fig. G). The
mitre saw bevel cuts from 0°
to 45° to the left and right. To
adjust the bevel angle loosen
the bevel lock and pull out the
0° bevel adjuster (18). Adjust
the saw arm to the desired
bevel angle.
WARNING. Be sure to tighten
the bevel lock before making a cut. Failure to do so could
result in the saw arm moving during the cut and cause
serious personal injury.0°

Bevel adjuster

The bevel adjuster (18)
needs to be pulled out before
the bevel angle can be
adjusted (Fig. H).
F
G
H
To return the saw arm to the vertical (0° bevel)
position move the saw arm to the left and push in the
0° bevel adjuster.
Return the saw blade to the vertical position, it will automatically
stop at the 0° bevel position. Tighten the bevel lock.

Clamp assembly

The clamp assembly (10) can be mounted to the fence,
either side of the saw blade, to suit the task at hand (Fig. I).
I
Use the clamp assembly lock (11) at the back of the fence
to secure the clamp assembly in position (Fig. J).

Spindle lock button

The spindle lock button (26)
prevents the blade in the
saw from rotating (Fig. K).
Depress and hold the
spindle lock button while
installing, changing, or
removing the blade.
Rotating lower
blade guard
The rotating lower blade
guard (12) provides
protection from both sides of
the blade (Fig. L). It retracts
over the upper blade guard
(9) as the saw is lowered into
the workpiece.
10
J
K
L