Dust Bag; Attaching The Side Bars; Trench Depth Adjustment; Turning On And Off - GMC DB250SMS Anleitung

Dust bag

The dust bag (15) fits over
the dust extraction port (27).
For more efficient operation,
empty the dust bag when it
is no more than half full. This
allows better air flow through
the bag (Fig. M).
Attaching
the side bars
The side support bars (37)
help to support the material
when working with long
workpieces. There are two
location holes (38) for a
support bar on either side of
the table. Loosen the lock
screws (39) with the 6mm
hex key. Ensure the side
bars are fully inserted before
using them to support the
workpiece (Fig. N).
The side support bar
locking screws (39) must
be tightened to secure the
support bars in position
(Fig. O).
Trench depth
adjustment
In its normal position, the
trenching stop (31) permits
the saw blade to cut right
through a workpiece. When
the saw arm is lifted, the
trenching stop can be moved
to the left so that the trenching
depth adjustment screw (30)
contacts the stop as the saw
arm is lowered. (Fig. P). This
M
N
O
P
restricts the cut to a "trench" in the workpiece. The depth
of the trench can be adjusted with the trenching depth
adjustment screw (30) (Fig. Q) and locked in position with
the trenching depth lock nut (32) (Fig. R).
Q

Turning on and off

1. To turn the saw on depress
and hold the on/off trigger
switch (24) (Fig. S).
2. To turn the saw off release
the on/off trigger switch (24).
Turning on the laser
line generator
The laser line generator emits
2 intense narrow beams of
pure red light to guide you as
you cut.
It improves operator cutting
vision, enables faster set-up,
increases accuracy and
improves safety. To turn on
the laser lines press the laser
light on/off switch (2) (Fig. T).
To turn off the laser press the
laser light on/off switch (2)
one more time.
11
R
S
T
GB