Connecting Rackmounted Peripherals - Sun Microsystems Sun Enterprise 450 Produkthinweise

Rackmounting the Sun Enterprise 450
Server
An optional rackmounting kit is available for installing a Sun Enterprise 450 server
into a EIA standard 19-inch rack. For additional details, contact your Sun authorized
sales representative.
Rackmount placement information for the Sun Enterprise 450 server is available
through the Web at the URL:
http://docs.sun.com
Click on "Storage & Peripherals" in the Hardware section and open the Rackmount
Placement Matrix.
Note – Before installing the Sun Enterprise 450 server in a Sun Enterprise Expansion
Cabinet, be sure to remove the kick plate at the bottom rear of the cabinet. Removing
the kick plate allows two Sun Enterprise 450 servers to fit inside the cabinet. For
additional details, see the documentation supplied with the Sun Enterprise
Expansion Cabinet.

Connecting Rackmounted Peripherals

When connecting a deskside Sun Enterprise 450 server to any rackmounted
peripheral, be sure to connect an appropriate grounding strap between the server
and the rack enclosure. This strap prevents ground loops between the two systems
and guards against possible data loss.
A grounding strap is typically provided with the rack enclosure. Attach one end of
the strap to the designated ground point on your rack enclosure, according to the
instructions provided with the enclosure. Attach the other end to the ground screw
on the Sun Enterprise 450 server, as shown in the next figure. Be sure to tighten the
ground screw completely to ensure a good connection.
Sun Enterprise 450 Server Product Notes en-21