Watching The Picture; Switching The Input Signal - Sony PFM-50C1 Bedienungsanleitung

Watching the Picture

Watching the Picture
Before you start
• Turn on the display.
• Turn on the connected equipment and play a video
source.
• To display the input signal information and Picture
Mode on the screen when turning on the power or
switching the input signal, set "Display" in the
Custom Setup menu to On.
• To select the on-screen language used in the menu,
see page 41 (GB).

Switching the Input Signal

1
Press MENU.
The main menu appears on the display panel.
P i c t u r e / S o u n d
P i c t u r e
A d j u s t P i c t u r e
A d j u s t S o u n d
, t o s e l e c t ,
e n t e r a d j .
2
Press M/m to move the cursor (yellow) to "Input
Select" and press ENTER.
Input Select menu appear on the display panel.
I n p u t S e l e c t
I N P U T 1 ( R G B )
I N P U T 1 ( C O M P O N E N T )
I N P U T 2 ( R G B )
I N P U T 2 ( C O M P O N E N T )
V I D E O ( C O M P O S I T E )
V I D E O ( Y / C )
, t o s e l e c t ,
t o e x e c u t e
3
Press M/m to move the cursor (yellow) to the
input source to be displayed and press ENTER.
INPUT1 (RGB): Selects the audio and video
signal input from the INPUT1 connectors
when the input signal is an RGB signal.
INPUT1 (COMPONENT): Selects the audio and
video signal input from the INPUT1
connectors when the input signal is a
component signal.
26
(GB)
C o n t r o l
M o d e : S t a n d a r d
, t o
ENTER
m e n u
p r e s s
ENTER
INPUT2 (RGB): Selects the audio and video
signal input from the INPUT2 connectors
when the input signal is an RGB signal.
INPUT2 (COMPONENT): Selects the audio and
video signal input from the INPUT2
connectors when the input signal is a
component signal.
VIDEO (COMPOSITE): Selects the audio and
video signal input from the COMPOSITE
IN connector and AUDIO IN jack among
the VIDEO connectors.
VIDEO (Y/C): Selects the audio and video signal
input from the Y/C IN connector and
AUDIO IN jack among the VIDEO
connectors.
The selected input signal appears on the display
panel.
Color system or horizontal/vertical frequency
Signal type
I N P U T 1 ( R G B )
1 0 2 4 7 6 8 / 6 0
S t a n d a r d
Picture mode
You can switch the input signal using the Remote
Commander supplied with your display panel.
Notes
•We recommend input source video equipment
equipped with a TBC (time base corrector). If the
display receives a signal without TBC, the picture
may disappear due to disturbance of the sync signal.
•If signals of the same format are input from multiple
systems, the Picture Quality setting will default to
the most recently set value (Only when the signal
formats are identical).