Dust Extraction - Triton TRBS12 Bedienungs- & Sicherheitsanweisung

2. Insert the Fence Track (8) until it stops against
the table and the wing screws.
3. Secure the fence track
to the table, as shown,
using the two M6 Cap
Screws (48) and Spring
Washers (38), using the
6mm Hex Key (35).
4. Tighten the four wing
screws.
5. With its lock lever
raised, locate the Fence
(9) into the fence track
on the right side of the
saw blade. Slide it
alongside the table slot,
lock down the lever and
check that it is parallel to the slot. If necessary
use the 6mm Hex Key
(35) through the access
hole in the top of the
fence to loosen the hex
screw and adjust the
fence parallel to the slot.
Re-tighten the screws.
6. Locate the fence exactly 50mm from the saw
blade. The scale line on the magnifying glass
should now read 50mm. If necessary, loosen
the Phillips-head screw on the left hand end of
the scale extrusion to fine-tune the position of
the scale.
Re-check that the fence is still parallel to the
table groove (repeat point 5).
FITTING THE SPEED CONTROL WHEEL
1. Screw the Wheel Handle (29) onto the Speed
Control Wheel (28), and tighten with the
Spanner (33)
GB
Setting Up
8
2. Slide the speed control wheel onto the bolt
on the right side of the machine, as shown.
Secure it into position using an M8 Nyloc Nut
(46) and M8 Washer (45).
FITTING THE BLADE TENSIONING KNOB
Fit the Saw Blade
Tensioning Knob (13) onto
the bolt on top of the
machine and secure it into
position using an M8 Hex
Nut (47) and Washer (45).
SAW BLADE TENSION
Saw blade tension is dependent on the width
of the saw blade – broad saw blades require a
greater tension than narrower ones.
• Adjust the Saw Blade
Tensioning Knob (13)
while using the gauge on
the rear of the bandsaw
to set the required
tension for your saw
blade width.
Too much tension can cause premature
breakage of the saw blade.

DUST EXTRACTION

• When used in enclosed spaces, the machine
must be connected to a vacuum exhaust unit
to remove sawdust. The vacuum support flow
rate must be 20m/s.
• A dust extractor which conforms with
commercial regulations must be used for
suction in commercial areas.
• Do not switch off or remove dust extraction
while the machine is in operation.
• Connect your dust extraction device hose to
the Dust Extraction Port (26) on the bandsaw
using a 4" dust extraction hose.
POWER
This product is designed to operate from a
standard household supply of 230-240V AC.
Prior to plugging in the tool, check the rating label
tool and ensure that it states that the operating
voltage is 230-240V.