Triton TRBS12 Bedienungs- & Sicherheitsanweisung Seite 5

e. Always unplug the power tool when leaving
it unattended. Such preventative safety
measures reduce the risk of starting the
power tool accidentally by untrained users.
f. Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
operation of the power tool. If damaged, have
the power tool repaired before use. Many
accidents are caused by poorly maintained
power tools.
g. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
h. Use the power tool, accessories and tool bits,
in accordance with these instructions and in
the manner intended for the particular type of
power tool, taking into account the working
conditions and the work to be performed. Use
of the power tool for operations not suited to
the tool could result in a hazardous situation.
5. Service
a. Have the power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
ADDITIONAL SAFETY
WARNINGS FOR BANDSAWS
• Ensure that the lighting is adequate.
• Keep the area free of tripping hazards.
• Always stand to one side when operating the
machine.
• Never use a cracked or distorted blade. Only
use sharp blades.
• When cutting round wood, use clamps that
prevent the workpiece from turning on the
table.
• Never use your hands to remove sawdust,
chips or waste close to the blade.
• Use only blades as recommended.
• Rags, cloths, cord, string etc. should never be
left around the work area.
• Avoid cutting nails. Inspect the workpiece
and remove all nails and other foreign objects
before sawing the workpiece.
• Support the work properly.
• Never reach over the blade to remove waste or
off cuts.
• Do not attempt to free a jammed blade before
first switching off the machine.
• Do not slow or stop a blade with a piece of
wood. Let the blade come to rest naturally.
• If you are interrupted when operating the
machine, complete the process and switch off
before looking up.
• Periodically check that all nuts, bolts and other
fixings are properly tightened.
• Do not store materials or equipment above a
machine in such a way that they could fall into
it.
• Ensure that your work is always on the table.
Never make a cut with the work off the table.
• Wear goggles, earmuffs, and a breathing
mask.
TRANSPORT WARNINGS
The machine may only be lifted and transported
by holding the rigid parts of the main body.
Lifting the machine by any of the table, knobs or
levers can damage the machine.
During transport the saw blade protection must
be in the lowest position and close to the table.
Unplug the machine from the mains before
transport.
Safety Instructions
5
GB