Triton TRBS12 Bedienungs- & Sicherheitsanweisung Seite 7

8. Screw the two M6 Cap Screws (40) into the
holes in the Handle (30). Insert the handle
through the handle brackets, aligning the
screws with the keyhole slots to enable it to be
slid fully under the machine.
IN USE: The handle pulls
out to aid in wheeling the
bandsaw to an alternative
location. Slide the handle
out and rotate until the
second screw locates
against the handle bracket
furthest from the front of the machine. Use the
handle to raise the front of the bandsaw and
carefully guide it to the required position.
FITTING AND ADJUSTING THE TABLETOP
1. Release the Table Angle Lock Lever (25) and
angle the Table Base (23) to 0° using the Table
Base Angle Adjuster (24). Re-lock the angle
adjuster lever.
2. Locate the Table (22) onto the table base, as
shown, and loosely screw into position using
the four M8 x 16mm Hex Bolts (45) and M8
Washers (46).
Release the Door Locks
(15 & 27) and open the
Access Door (12).
3. Place a straight edge
against the back
edges of the saw
blade, as shown, and
use a square against the straight edge and the
table groove to position the table square to the
saw blade.
4. Release the angle adjuster lock lever by a half
turn and tighten all the bolts.
5. Place a square against the side of the saw
blade and adjust the table square to the saw
blade using the Angle Stop Bolt (7) beneath the
table.
Tighten the lock nut down onto the post to lock
in the position. Lock the angle adjuster lever.
ASSEMBLING AND ADJUSTING THE FENCE
1. Screw in the four Wing Screws (42), each with
a Large Washer (45), approximately 5mm into
the underneath of the table, as shown.
GB
Setting Up
7