Electrolux IK245S Benutzerinformation Seite 15

Problem
Temperature cannot be
set.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Possible cause
The FastFreeze function is
switched on.
The FastCool function is
switched on.
The appliance is in demon‐
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
The FastCool function is
switched on.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
ENGLISH
Solution
Switch off FastFreeze
manually, or wait until the
function resets automati‐
cally to set the tempera‐
ture. Refer to "FastFreeze
function"
Switch off FastCool man‐
ually, or wait until the func‐
tion resets automatically to
set the temperature. Refer
to "FastCool function".
Keep the button pressed
for approximately 10 sec‐
onds until a long sound is
heard and display shuts off
for a short time.
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion".
Refer to "FastCool func‐
tion".
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable
packaging before storing it
in the appliance.
15