Lcd-Display - ION iTT03X Schnellbedienungsanleitung

TONE ARM ASSEMBLY
22
23
Headshell- Install cartridge here.
18.
When installing a cartridge, refer to
the installation instructions supplied
by the manufacturer of that
cartridge. During installation, attach
the stylus protector to guard the
stylus tip from damage.
Attach wires as follows:
White (L+)Left channel +
Blue (L-) Left channel
Red (R+) Right channel +
Green (R-)Right channel
19. Headshell Locking Nut - Attach
headshell by inserting into the front
end of the tonearm, then turn the
locking nut clockwise with the head
shell firmly held horizontally.
20. S-Shaped Tone Arm
21. Tone Arm Clamp and Rest - Use this
rest for the tone arm and clamp it in
position during transportation.
22. Tone Arm Lift - This elevates the
tone arm above the record surface.
23. Tone Arm Lift Adjust Screw -
Controls the amount of lift.
24. Tone Arm Lever - Controls the up
28
and down action of the Tone Arm
Lift.
27
25. Anti-Skate Control - This applies
inward force to the tonearm so it
doesn't skip outward across the
26
record due to the centrifugal force of
the record spinning. Cartridge
25
manufacturers usually specify the
proper setting of this.
26. Tone Arm Height Adjust - This allows
24
the tone arm to be properly align
with the platter surface.
21
27. Height Lock - Prevents accidental
adjustment of the height.
28. Counterweight - Adjustment creates
the proper downward pressure of the
stylus to the record.
sliding the counterweight onto the
rear of the tonearm. Twist it lightly
and it will screw onto the rear shaft
of the tonearm.
20
19
LCD DISPLAY
18
31
29
29. Speed Indication
30. Speed Adjust Indication - This will
display adjustments in platter speed
made by the pitch control.
31. Play/Pause - Indicates current state
of the platter
32. Pitch/Quartz - Indicates current
mode of operation
33. Platter Wheel - Simulates all actions
of speed and direction of the platter.
Attach now by
32
33
45
33 + 45 - 78 rpm
33
30
- 33 rpm
- 45 rpm