Choosing The Mode - HQ Power VDPLP708RGBW Bedienungsanleitung

SouA
LED
nodE
UErn
7.2

Choosing the Mode

You can use the device on its own as a stand-alone unit or connect it to other similar fixtures.
Stand-Alone Mode
In stand-alone mode, the device runs on one of the built-in programmes or with sound activation.
To set the device to stand-alone mode:
1. Unplug any connection from the DMX input [4] of the device.
2. Press MENU and choose one of the playing modes – built-in programmes or sound activation – with
UP or DOWN.
3. Press ENTER to confirm.
4. Choose the mode value with UP or DOWN and press ENTER to confirm.
Master/Slave Mode
The master/slave mode allows connecting several devices to a single master device. All slave devices will
then work synchronously with the master device.
Set one device to master mode and all other devices to slave mode.
1. Unplug any connection from the DMX input [4] of the master device (the first device in the chain).
2. Connect the DMX input of the first slave device to the DMX output [5] of the master device.
3. Connect the DMX input of the subsequent slave devices to the DMX output of the previous slave
device.
4. Set up the master unit as described in Stand-Alone Mode.
5. On each slave device, press MENU until <SLAU> appears. Press ENTER to confirm.
DMX Channel Values
3 channel mode:
Channel From
1 0
2 0
3 0
4 channel mode:
Channel From
1
2
3
4
5 channel mode:
Channel From
1
2
3
4
5
V. 01 – 20/06/2014
sound activation
display on/off
DMX dimming
software version
To Description
255 RGB colour mix
255 white dimming from 0-100 %
255 general dimming from 0-100 %
To Description
0 255 red from 0-100 %
0 255 green from 0-100 %
0 255 blue from 0-100 %
0 255 white from 0-100 %
To Description
0 255 general dimming from 0-100 %
0 255 red from 0-100 %
0 255 green from 0-100 %
0 255 blue from 0-100 %
0 255 white from 0-100 %
VDPLP708RGBW
6 ©Velleman nv