Procedures For Use; Checks Prior To Start-Up - Ravelli HRB 150 Bedienungs- Und Wartungshandbuch

To avoid unwanted startup and shutdown operations, activate only one program at a time.
MENU 04 – Select language
With this selection it is possible to set the desired language from those available.
MENU 05 – Standby mode
By selecting ON in STANDBY mode the corresponding symbol on the display lights up and the stove shuts down automatically when
the room temperature T has reached the set value (Tset + ΔT) for a given time. The next restart in automatic will be possible only
when the room temperature falls below the set value by a few degrees and precisely (Tset - ΔT) where ΔT default = 2°C. With the
OFF selection, the modulation function is active but not the STANDBY mode. Therefore when the temperature exceeds the set value
the stove will operate at minimum power.
MENU 06 – Buzzer mode
With this selection it is possible to activate or deactivate the stove acoustic signals for alarms.
MENU 07 – Initial load
Allows the preloading of pellets for a given time. This function can only be activated when the stove is off and is used if the auger is
empty due to no more pellets. It is started with button P1 and stops with button P3.
MENU 08 – Stove/stove status
This selection is reserved for the Aico SpA service center authorized technician.
MENU 09 – Technician settings
This selection is reserved for the Aico SpA service center authorized technician.
Modification of the technical parameters of menu 09 must be done by authorized and competent personnel; any
random changes made can cause serious damage for which Aico SpA declines any liability
MENU 10 – Installer settings
This selection is reserved for the qualified installer and/or Aico SpA service center authorized technician.

PROCEDURES FOR USE

If the chimney catches fire you must call the fire brigade immediately.

Checks prior to start-up

You have read and perfectly understood the contents of this instructions manual.
Before lighting the stove, you must ensure that:
•
the combustion chamber is clean;
•
every element that could burn has been removed (instructions, various stickers).
! IMPORTANT
! IMPORTANT
Recharge the fuel
Use only wood pellets, the characteristics shown in this manual.
During pellet loading prevent the pellet bag from coming into contact with hot surfaces.
Switching the appliance on and off
From the "stand-by" screen, it is possible to switch the stove on and off by keeping the ON / OFF button pressed on the device for a
few seconds. An acoustic signal will warn you that the appliance has switched on or off. In case it is not possible using your handheld
you can switch the appliance on / off using the appropriate button on the electronic board.
Do not switch off the heater by unplugging the plug from the wall socket.
Use and maintenance manual HRB 150 - HRB 200
During the first hours of use the paints used for the stove finish may release an unpleasant
odour. You might also smell the typical odour of metal parts subject to high temperatures. Make
sure sufficient air circulation is guaranteed in the room. These unavoidable inconveniences
will disappear after the first hours of operation. To reduce your discomfort to a minimum,
keep the stove on for a few hours on low power and in the beginning, do not overload it,
avoiding intense heating-cooling cycles.
At the initial start-up, the paint finishes drying and hardens. Accordingly, to avoid ruining it,
we advise you not to touch the stove's painted surfaces at this time.
Rev.1 14/02/18
Page 55
EN