Livin Flame Jura Montageanleitung Und Gebrauchsanweisung Seite 21

Mood Light
6b.6 Press to enter the mood light adjustment screen.
6b.7 Press the '←' and '→' button to select one of the 13 mood light colours or 14th option of
the continuous cycle mode.
6b.8 Press the '+' and '-' button to to select the 5 brightness of mood light and OFF settings.
Normal Mode
6b.7 Normal control mode is factory set. If it is not, then press button until the logo shows up
at the upper right corner of the screen.
6b.8 Press the '+' and '-' button to adjust the setting temperature from 17℃ to 25℃ by 2
intervals.
6b.9 Press button to turn on/off heat, ON、 OFF will show at the lower of the screen.
NOTE: It is normal for the fan heater to stop running for periods of time. This happens because
the room temperature is at or above the temperature set on the remote control. The heater
indicator will be turned off after 10s if you have the flame ON. The heater indicator will stay ON if
you use the heating function only.
Count Down Timer
NOTE: This setting is only for normal mode. It allows the appliance to go into standby after a set
period of time.
6b.10 Press to cycle through the settings from Off and 0.5 hours to 9 hours. The timer logo and
time will show on the screen. The heater must be in the ON position.
The heater can be automatically run by using daily timer and weekly timer on the remote.
Set up Day, Time and Comfortable temperature
6b.11 Press to turn on the remote handset. Hold the button for 3 seconds to enter the setting
screen.
6b.12 Press the '←' and '→' button to choose Day, Time or your comfortable temperature. The
character selected will be highlighted.
6b.13 Pressing the '+' and '-' button to adjust the number.
• Time: 24-hour system
• Select your comfortable temperature from 15-25℃.
• Temperature unit: ℃、℉
Daily Timer Heating
6b.14 The following are preset heating periods, which can be altered if desired.
06:00 until 08:30
17:00 until 22:00
6b.15 Press until shows at the upper right corner of the screen, then enter the daily timer
heating mode.
6b.16 Hold the arrow symbol button for 6 seconds to enter The daily timer setting. Max 3
timed Heating periods for a day.
• Press '←' or '→' to choose hour or minute,press '+' or '-' to set the number.
• Minute will increase/decrease by 15 minutes per press.
• Hold for 3 seconds or wait for 10 seconds to save and exit the heating time period setting.