Velleman CAMCOLI3N Bedienungsanleitung Seite 5

4. Features
ideal for checking hard-to-reach areas, e.g. behind walls, suspended ceilings, etc.
4 built-in white LEDs
adjustable LED intensity
video mirror function
comes with: 3 exchangeable top-pieces
magnetic top: to pick up small metal pieces
o
hook: to retract wires or other small objects
o
mirror: to look behind corners or in shallow holes.
o
5. Overview
Refer to the illustrations on page 2 of this manual.
1 camera head with LEDs
2 gooseneck (± 85 cm)
3 gooseneck connector
4 power on LED
5 low power LED
6
power button
6. Preparation
Refer to the illustrations on page 2-3 of this manual.
Mounting the Gooseneck
1. Place the gooseneck [2] on the gooseneck connector [3]. The protrusion must fit into the
groove [A].
2. Turn the nut anti-clockwise all the way to secure the gooseneck [B].
Installing/Replacing Batteries
1. Slide the battery cover downwards to open it [C].
2. Remove the battery holder from the housing [D].
3. Insert 4 identical AA batteries into the battery holder. Respect the polarity as indicated inside the
holder [E].
4. Slide the battery holder back into the housing and close the cover.
Warning: Do not puncture batteries or throw them in fire as they may explode. Do not
attempt to recharge non-rechargeable batteries (alkaline). Dispose of batteries in accordance
with local regulations. Keep batteries away from children and pets.
Attaching Tools
Place the plastic clamp of the tool over the narrow part of the camera head as indicated [F] and close it.
Make sure it snaps into place.
Attach the magnetic top to the camera to pick up small metal pieces from difficult to reach locations.
Attach the hook to retract wires or other small objects.
Use the small mirror to look behind corners.
7. Use
Never insert the camera in energised/operational machines or equipment.
1. Press the power button [6] to switch on the camera and display.
The power on LED [4] lights up.
Note: When the low power LED [5] lights up, you must replace the batteries (see § 6).
2. Press the LCD brightness button [10] to set the preferred brightness of the LCD (8 steps).
3. Press the LED brightness button [9] to adjust the intensity of the LEDs on the camera head [1]
(7 steps).
V. 02 – 24/09/2013
CAMCOLI3N
7 handle
8 mirror display
9 LED brightness
10 LCD brightness
display
11
5 ©Velleman nv