Commissioning Your Wine Cabinet; Ii-A - Description (I-Temperature Model V083 - V183 - V283); Iii-A. Temperature Setting - Eurocave Classic Serie Gebrauchsanweisung

1. Connection and starting up
Wait 48 hours before plugging in your wine cabinet.
To switch it on, press and hold down button
Have your plug checked (presence of fuses, amps and 30 mA
circuit breaker).
Do not plug several cabinet into a multi-socket.
1I-A. Description (1-temperature model V083 - V183 - V283)
A B C D
P O
A
Lighting mode
B
Open door alarm
C
Temperature zone
D
Sensor fault alarm
E
Temperature alarm
F
Charcoal filter alarm
G
Confirmation and setting access key
H
Setting and selection keys

III-A. Temperature setting

Press and hold down the key to power up.
1
Press and hold down the
The display will start to flash
2
Press the or keys to set the desired temperature.
3
Press the button to confirm.
7 - c
ommissioning your Wine cABinet
for 5 seconds.
E F
N M L
5 sec.
key for approximately 5 secs.
Check your type of wine cabinet
Press the and keys at the same time.
G H I
K J
I
Lighting mode access and confirmation key
J
Charcoal filter meter access key
K
Power button
L
Humidity level alarm
M
Relative humidity level display
N
Hot circuit indicator
O
Cold circuit indicator
P
Temperature display
The value shown on the display is the actual temperature inside
the cabinet. It is therefore necessary to wait before your new
setting takes effect.
•
The default setting is 12 °C (ideal wine maturing temperature).
However you can set the temperature between 5 - 22 °C.
•
Recommended wine maturing temperature setting range: 10 - 14 °C.
N.B: in order to operate correctly, your cabinet must be placed in a room
with a temperature of 0 - 35 °C.
The tactile keys are very sensitive.
There is no need to apply force, a light
touch is sufficient to register the
command. Remember to remove your
finger from the panel between presses.
11
EN