Troubleshooting - Fellowes POWERSHRED P-25S Bedienungsanleitung

BASIC SHREDDING OPERATION
Continuous operation:
Up to 3 minutes maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3 minutes will trigger a
25-minute cool down period.

TROUBLESHOOTING

Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.
1 2
Set to Reverse (R)
Alternate slowly back and forth
for 2-3 seconds
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 1 year from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 1 year from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
PAPER
1 2
Set to Auto-On (I) Feed paper straight
into paper entry and
release
3 4
3
When finished
shredding set to
OFF (O)
5
Gently pull uncut
Set to Off (O)
paper from paper
and unplug
entry. Plug in.
additional costs incurred by Fellowes to provide parts or services outside of the country where the
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
more details or to obtain service under this warranty, please contact us or your dealer.
Shredder doesn't start:
Make sure head is on basket
6
correctly
Make sure switch is in auto
position (I).
Check for jam.
Set to Auto-On (I) and
resume shredding
Remove and empty basket.
Wait 25 minutes for motor to
cool down.
3