ASROCK X99 Extreme4 Bedienungsanleitung Seite 24

Power LED Header
(3-pin PLED1)
(see p.1, No. 18)
Serial ATA3 Connectors
(S_SATA3_0_1:
see p.1, No. 11)
(S_SATA3_2_3:
see p.1, No. 12)
(SATA3_0_3:
see p.1, No. 13)
(SATA3_1_4:
see p.1, No. 14)
(SATA3_2_5:
see p.1, No. 15)
USB 2.0 Headers
(9-pin USB4_5)
(see p.1, No. 22)
(9-pin USB6_7)
(see p.1, No. 23)
USB 3.0 Header
(19-pin USB3_4_5)
(see p.1, No. 9)
22
1
PLED-
PLED+
PLED+
USB_PWR
P-
P+
GND
DUMMY
1
GND
P+
P-
USB_PWR
Vbus Vbus
Vbus IntA_PB_SSRX-
IntA_PB_SSRX+
IntA_PA_SSRX-
IntA_PA_SSRX+ GND
IntA_PB_SSTX-
GND
IntA_PA_SSTX-
IntA_PB_SSTX+
IntA_PA_SSTX+
GND
GND IntA_PB_D-
IntA_PA_D- IntA_PB_D+
IntA_PA_D+
Dummy
1
Please connect the chassis
power LED to this header
to indicate the system's
power status.
hese ten SATA3
connectors support SATA
data cables for internal
storage devices with up
to 6.0 Gb/s data transfer
rate. If the eSATA port
on the rear I/O has been
connected, the internal
S_SATA3_3 will not
function. If the Ultra M.2
Socket has been occupied,
the internal S_SATA3_2
will not function.
* RAID is supported on
SATA3_0 ~ SATA3_5
ports only.
Besides four USB 2.0 ports
on the I/O panel, there
are two headers on this
motherboard. Each USB
2.0 header can support
two ports.
Besides four USB 3.0
ports on the I/O panel,
there is one header on this
motherboard. his USB
3.0 header can support
two ports.