QuickLabel QL-800 Kurzanleitung Seite 11

12. When the back of the printhead is firmly in place, gently rotate the printhead cartridge
forward into position against the stops on the printhead connector circuit board.
If the printhead will not rotate into position, do not force it. Remove the printhead and
try again.
13. Slowly close the printhead latch. The fluidic couplings should advance and seal to the
printhead cartridge.
If the latch will not close, do not force it. Remove the printhead and try again.
14. Close the top cover.
15. Finish the After Shipping wizard in the QL-800 Maintenance Utility.
16. Open the top cover and verify that ink has filled all of the five tubes shown below.
If ink is not visible in all of the indicated tubes, contact Technical Support. Do not run
the After Shipping Wizard in the QL-800 Maintenance Utility again or an ink overflow
may occur.
17. Close the top cover.
QL-800 Quick Start Guide 9