Klarstein Silent Storm Bedienungsanleitung Seite 20

EN
20
OSC (Swinging)
After the fan has started, press this button repeatedly to start and stop
swinging.
PRO (Timer)
When the fan is running, press the Timer button to set an off timer. The timer
icon flashes every second in the display.
Turn the rotary knob clockwise to set the hours as follows:
0.5 > 1.0 ... > 12.0 > 00.
Turn the knob counterclockwise to set the time as follows:
7.5 > ... 0.5 > 00 > 12.0 > ...
If you have set the time, wait 5 seconds until the set time flashes twice in the
display and a beep indicates that the time has been accepted. As soon as
the set time has been accepted, the fan returns to the normal operating mode
and the timer icon stops flashing. To cancel the timer, press the timer button for
5 seconds. If the setting was successful, the display will show the wind force
again.
In standby mode, press the timer button to program an on timer. The timer icon
will light and you can enter the time. Turn the Rotary encoder again to set the
desired time. When you are finished, the display will show the set time. To
cancel the timer, press the Timer button several times.
Note: If you set the time in the On state, you can briefly check the time
after setting and change it within 5 seconds. If you do not make a
setting for 5 seconds, the set time flashes twice in the display, then the
display shows the wind speed again.
Operation via the control panel on the device
Speed control knob for
setting the speed
Swing
On/Off