Connect The Power Cable To The Camera - Axis Communications AXIS T92A00 Installationsanleitung

AXIS T92A00 Installation Guide

Connect the power cable to the camera

4
1. Using the small flathead screw
driver, loosen the screws in the
Power to camera connector on
the connector board (fig.3).
2. Insert the red (+) and black (GND)
wires in the connector and
tighten the screws to secure the
wires.
3. Connect the wires to the green terminal connector on the Axis network camera (fig.4).
4. Proceed to "Route the cables to the housing" on page 8.
Note:
The camera models have different terminal connectors. Be sure to follow the correct description
for the installed camera.
FIG. 4
AXIS 211/211A/211M/211W
AXIS 210/210A
AXIS Q1755
+
GND
FIG.3
AXIS 221
+
GND
+
GND
AXIS 223M
+
GND
AXIS P1311
GND
Power to
camera
GND
+
1 2 3 4 5 6 7 8 9 10
RESET
PWR NET
NETWORK / POWER
POWER
AC AC
GND DC+ RS-232
+
GND
+
Page 7