Install The Bracket - Axis Communications AXIS T92A00 Installationsanleitung

AXIS T92A00 Installation Guide

Install the bracket

2
Install the mount for AXIS T92A00 on a wall ceiling or pole and make sure that the screws and
plugs are appropriate for the material (e.g. wood, metal, sheet rock, stone). Check if the wall bracket
has A an internal cable channel or
description below and install the wall bracket in the intended position.
A
Alt
Wall bracket with internal cable channel
1. Install the wall bracket/holder on a wall, ceiling or pole using the appropriate screws for the
weight of the housing and the material.
2. Attach the rubber gasket and make holes for the cables.
3. Pull a sufficient length of the cables through for the housing and camera (approximately
50cm).
rubber gasket
cables
A
Wall bracket (internal cable channel)
4. Proceed to "Install the camera in the housing" on page 6.
B
Alt
Wall bracket with external cabling
1. Install the cables and wall bracket/holder on a wall, ceiling or pole. To comply with the
IP66-rated design of AXIS T92A10, it is necessary to use appropriate conduits to protect the
cables.
2. Proceed to "Install the camera in the housing" on page 6.
Note:
Please visit the Axis web site at www.axis.com for a comprehensive list of available brackets and
accessories.
B if the cabling is external. Select the corresponding
cables
B
Wall bracket (external cabling)
Page 5
cables