Axis Q60 Serie Installationsanleitung Seite 11

AXIS Q6032-C/Q6034-C/Q6035-C Installation Guide
Multi-Connector Cable
The supplied multi-connector cable is required in order to maintain the camera's IP rating.
Connect the multi-connector cable to the camera's multi-connector and to the
connectors in the supplied media converter switch, see illustrations on page
page 6 and page 8. The cable provides the following signals:
• DC power
• Network (Ethernet 10/100Base-T)
• I/O
Function Pin Wire
Configurable 2, 7 Blue, yellow
(Input or
Output)
RX+ 3 Green/white
RX- 4 Green
TX+ 5 Orange/white
TX- 6 Orange
GND 8 Black
12 V Power 1, 9 Red
Notes
Digital input – Connect to GND to activate, or
leave floating (unconnected) to deactivate.
Digital output – Internal connection to ground
when activated, floating (unconnected) when
deactivated. If used with an external relay, a
diode must be connected in parallel with the
load, for protection against voltage transients.
Ethernet – receiving
Ethernet – receiving
Ethernet – transmitting
Ethernet – transmitting
Ground
Used to power camera
Page 11
1 8
2 7
9
3 6
4 5
Specifications
0 to +30 V DC
Max load =100 mA
Max voltage =
+30 V DC
12 - 13.2 V DC
Max load = 6 A