1 - SCOPE
This tool has been designed to assemble and disassemble screws in wood, metal and plastic materials. No other use will be per-
mitted. For professional use only.
2 - GENERAL INSTRUCTIONS
To reduce risk of injury, everyone using, installing, repairing, maintaining, changing accessories on, or working
near this tool must read and understand the safety instructions before performing any such task. Failure to follow
all instructions listed below, may result in electric shock, fire and/or serious personal injury.
General safety instructions are collected in the 6159930690 safety booklet.
Specific instructions are given below.
3 - PERSONAL SAFETY
3.1 - Earthing connection
WARNING: this power tool must be earthed.
3.2 - Differential circuit-breaker
Always use a differential circuit breaker to protect the operator from electric shock. A differential circuit breaker in the
power supply to the tool detects any insulation defect between the phases of the network and the earth and immediately cuts off
the power supply to the tool.
3.3 - Power supply
Always use the cord supplied with the tool to connect to the mains power supply or CP Data Transfer Unit (DTU) only.
Do not modify the cord or use it for other purposes. Use only genuine CP replacement parts. Failure to follow these instruc-
tions may result in electric shock.
4 - TOOL USE HAZARDS
The selection of the tool takes account of the operating conditions as stated by the user, who shall not exceed the operating limits
as specified by the manufacturer at the time of the selection (see "Max duty cycle" file on the CDRom supplied).
Any excessive internal temperature of the tool electric motor if higher than 60°C is detected and stops the tool. It can start again
only if the temperature decreases to under 50°C.
Although our cables are designed to work under drastic conditions, we recommend that you check the following points for longer
service life:
•
bending radii should not be lower than 10 times the cable diameter,
•
friction with the outer sheath should be restricted,
•
any direct pull on the cable should be avoided.
5 - TOOL CARE AND SERVICE
Only experienced and qualified personnel (authorised electricians) are entitled to open and have access to the inside of
the tool. If in doubt, return the tool to a CP-authorized service centre (contact your local CP Sales for details).
Disconnect from power supply and wait one minute before commencing service operations. Failure to wait one minute may
result in electric shock from undischarged capacitors.
Beware hot components. There is a risk of burning by internal components which can reach 75°C (170°F). Allow to cool before
handling.
EAP/EDP
CHAPTER 1 - SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS CAREFULLY
Part no
6159936431
Issue no
06
Language English
Date
09/2009
24
Page
3 /