Stored Data; Usb Charger; Projection; Backlight - BEARWARE 302688/20171207FZ006 Bedienungsanleitung

9. Stored data

Maximum and minimum temperatures
Press the "MEM" button to view the indoor and outdoor temperatures. The
respective maximum readings are now shown on the display. Press the "MEM"
button again to view the minimum measured values. After 5 seconds, the current
reading is displayed.
Note: The min/max temperatures are measured from the total operating
time of the weather station. Press and hold the "-" key for approx. 3 seconds
to delete the stored maximum/minimum values.

10. USB Charger

A USB port is located on the left outer side of the weather station. Using this USB
port, for example, you can charge your mobile phone or MP3 player. Note that
the USB port has only one output and no inputs.

11. Projection

The projection is permanently switched on when operating with the power
adapter. If you use only batteries, the projection switches on for 15 seconds when
you press the "SNOOZE/LIGHT" button. The effective projection distance is 1-3
metres.
Press and hold the „-" button about 3 seconds to rotate the projection 180°.
The projection shows the current time and the indoor/outdoor temperature
alternately.

12. Backlight

If you operate the device with batteries, you can switch on the backlight for 15
seconds by pressing the "SNOOZE/LIGHT" button. Once the power adapter is
connected to the weather station, the backlight is switched on permanently.
You can dim the backlight by pressing the "-" button (3 levels).
English
27