GGG SP5010 Bedienungsanleitung Seite 19

the device under running water and to use pressure washers for this purpose.
In case of intensive use of the device, it is recommended that the filters are cleaned every 30-40 washing
cycles, in order to ensure the proper functioning of the device. For this purpose it is necessary to partially
empty the tank of water.
The filters should be removed and it must be ensured that the greasy deposits and food remnants do not
fall into the opening under the filters. The filters must be cleaned from the remnants of food and sediments
and then abundantly rinsed. Do not use sharp tools or sharp edges to clean the filters. Make sure that the lime
scale deposits are also removed, as that prevents their accumulation on the surface of the filter.
The surfaces of the filters should be thoroughly cleaned with a damp cloth using neutral (non-caustic)
detergents which do not contain chlorine and agents causing corrosion and mechanical damage to stainless
steel surfaces.
In order to avoid the creation of corrosive stains on the stainless steel surfaces, avoid the use of caustic
detergents containing chlorine and agents that cause corrosion and mechanical damage to the stainless steel
surface. Do not use detergents causing damage to stainless steel for cleaning the floor and the immediate
surroundings of the device.
Once a month, please check whether:
• make sure the power cord is not damaged;
• make sure that all components of the appliance are working properly,
• remove the washing arms (Fig. 13) (bottom and top 1 and 2) by loosening the screws (3 and 4) and clean
under the current water
• The external surface of the device should be cleaned using soap and a damp cloth and should then be
thoroughly rinsed and wiped dry.
In order to ensure the proper operation of liquid dispensers it is recommended that the tubes are replaced
every 6 months.
At least once a year the device should be inspected in order to check the degree of wear and to identify
possible faults of the components and parts of the device. In case any faults are detected, they have to be
removed by a qualified technical personnel (technical service). The technical service should pay particular
attention to:
• the condition of the heating elements
• the condition of the electrical installation
• the condition of the heating elements protections
• the degree of wear of the device
Although a special program of periodic device inspections has not been developed, it is recommended that
the correct operation of the device and its security features are verified by the technical service two times per
year. Any possible damage or failure of the device caused by the user's non-compliance with the guidelines
contained in this manual, as well as their failure to comply with the applicable laws and standards, will not be
treated as a liability of the manufacturer.
8.1. Breaks in the operation of the device
If it is expected that the device will not be used for a longer period of time, it is necessary to empty the
containers for the detergent and the rinse aid in order to prevent their crystallization and the resulting pump
damage. In connection with the above, it is necessary to remove the suction tubes from both containers and
place them in a bowl filled with clean water, carry out several washing cycles and then empty the tank of
water. Finally, the main switch should be turned off and the water valve should be closed. The suction tubes
should be reconnected to the containers only once the device is used again (the clear tube to the detergent
Fig. 13
- 19 -