Device Operation - GGG SP5010 Bedienungsanleitung

The water remaining in the dishes after the completion of the cycle is not suitable for drinking.
The device may not be independently operated by minors or persons with limited intellectual,
physical and sensory abilities, who are not able to fully comply with the rules contained in this manual. The
above mentioned persons may only operate the device under supervision.

6. DEVICE OPERATION

6.1. Activities carried out before the start of washing
Only use detergents and rinse aids intended exclusively for industrial dishwashers. It is prohibited to use
detergents intended for manual dish washing. We recommend using detergents produced specifically for this
dishwasher.
When filling the detergent containers, be careful not to accidentally activate the device, as this may
cause damage or failure of the device. It is prohibited to mix various detergents, as this may cause damage
to the dispenser. Industrial detergents may cause irritation. Therefore it is always necessary to follow the
instructions provided on the detergent packaging.
The valve
should be
The levels of
opened
detergent and
rinse aid in
the containers
6.2. Loading of the dishwasher
1. Plates
The basket can hold 12 deep plates or 18 flat plates. It is necessary to remove remnants of food from the
surface of the plates. Before washing plates with dried up remnants of cheese, eggs, etc., they should be left
in cold water in order to soak off.
2. Glassware
It is necessary to remove any residue from glasses, wine glasses, etc., and place them in the basket with
the bottom facing up.
3. Cutlery
Use the basket to washing cutlery. It is recommended that cutlery is placed with the handles facing down.
Knives and forks must be handled with appropriate care (risk of injury).
Check:
The correctness of the filters placement, the
correctness of the nozzle rotation, the throughput
of the device (whether there are any foreign bodies
inside the device which prevent the correct operation
of the device).
Fig. 6
- 16 -
The main
switch should
be turned off;
the "OFF" sign
will appear on
the display.
Fig. 7