Problems, Causes, Solutions; Maintenance - GGG SP5010 Bedienungsanleitung

7. PROBLEMS, CAUSES, SOLUTIONS

Note: If the activities for the removal of the faults described in the table below did not provide the desired
result, please contact the repair service (qualified technical personnel).
PROBLEM
The device does not
turn on
Washing process lasts
too long
The device does not
wash dishes
Spots on forks, glasses
and vessels
Dishwasher does not
rinse
Leaking solenoid valve
The water pressure in
the device is too low
The pump is not
pumping out water

8. MAINTENANCE

Before starting any maintenance work, disconnect the device from the power supply.
Daily maintenance involves the removal of all items from the chamber and washing it using a cloth
dampened in water with a dish washing liquid and then wiping dry with a clean cloth. It is prohibited to wash
CAUSE
The doors of the device are not closed
properly
Blown fuse
Improper connection to the electrical
network
Wash water temperature is not correct
Incorrect water level in the chamber of
the device
Broken washing pump
Low pump pressure
Water temperature too low
Incorrect washing agent
Arms covered with lime scale or the
presence of foreign bodies
Empty detergent container
Faults in the water treatment device
Incorrect arrangement of the dishes
Rinse water temperature is too high
Incorrect water pressure
Water hardness level is too high
The detergent did not work, because of
dirty water in the device
Incorrect drying of the dishes
Incorrect rinse agent
Contaminated water inlet filter
Low water pressure
Broken rinse pump
Contamination of the solenoid valve
Contaminated water inlet or solenoid
valve filter
Low hardness of water in the water
network
Clogged pump
Faulty pump
- 18 -
SOLUTION
Open and then close the door
again
Replace the fuse (call the
service)
Check the connection to the
electrical network
Set the correct temperature
Clean the water inlet filter
Call the service
Clean the pump filter
Adjust the water heating time
Contact the manufacturer
Clean the arms and remove the
foreign bodies
Fill the container
Kontakt mit Service
Arrange the dishes in
accordance with the instructions
Set the correct temperature
Clean the filters
Check the water hardness
Change the water in the device
Change the water in the device
Contact the manufacturer
Clean the filter
Clean the pump filter and the
solenoid valve
Call the service
Call the service
Note: during the installation
of the device foreign bodies or
unwanted chemical compounds
from the water supply could
have contaminated the solenoid
valve.
Clean the water inlet or solenoid
valve filter
Contact a plumber
Contact the service