GGG SP5010 Bedienungsanleitung Seite 17

6.3. Manual elements
1. Button functions
Fig. 8
2. Start-up of the device
Turn on the switch located on the wall, open the dishwasher door, place the overflow plug in the
appropriate place (fig. 8) and close the door of the device. Press the On/Off button (fig. 9). After the tank and
the boiler are filled with water the boiler heating element lamp will light up (bottom, fig. 12). After the heating
of water in the boiler is completed, the dishwasher chamber water heating cycle will begin – the chamber
heating element lamp will light up (top, fig. 12). Insert the basket into the device chamber and wait until the
indicator light of the chamber heating element turns off. Before starting the wash cycle, it is necessary to
select the program. Program 2 (120 s.) is the default program. After pressing the program selection button
we will switch to Program 3 (180 s.), which will be signaled by a flashing lamp (fig. 11), In order to start the
wash cycle, press the button (fig. 10). After starting the wash cycle, the indicator lamp will light up. If the
door is opened during the wash cycle, the program stops automatically. After the door is closed, the program
continues the wash cycle. After the program is completed, the wash cycle indicator lamp turns off, and the
boiler heating element lamp lights up. Remove the basket from the device chamber.
3. Emptying of the tank in models equipped with a drain pump
Open the door of the device, remove the overflow plug and close the door, turn the device off by pressing
the On/Off switch (fig. 9). The draining process proceeds automatically until the tank is completely emptied
of water. In order to reactivate the device, put the overflow plug back in its place, close the door and press
the On/Off switch. However, if the device will not be used any more, turn the main switch off.
In the event the device will no longer be used, after the completion of the above and the possible
initiation of a regeneration cycle, it is necessary to turn the device off by pressing the switch. The main switch
should then be turned off and the water valve should be closed.
4. Emptying of the tank in models not equipped with a drain pump
Turn the device off by pressing the switch (fig. 9), then open the door of the device, remove the overflow
plug (fig. 8) and wait until the water is drained off completely from the tank. Put the overflow plug back in its
place, close the door of the device.
Fig. 9 Fig. 10
On/Off Wash cycle
Fig. 11
Program
selection
- 17 -
Fig. 12
Indicator light for
chamber and boiler
heaters