MaxPro MPBBG150 Bedienungsanleitung Seite 6

Mounting the machine (fig. A)
The machine must be screwed to a workbench.
Mark the position of the mounting holes (8) on the workbench.
Drill holes at each of the marked position, adjusting the diameter and depth of the holes to the screws
used.
Place the machine on the workbench and insert the screws into the mounting holes.
Firmly tighten the screws.
Replacing a grinding wheel (fig. A & B)
Remover the wheel guard (3).
Loosen the nut (11). The nut on the right spindle has a right thread, the nut on the left spindle a left thread.
Remove the outer flange (12) and the old grinding wheel (2).
Clean the flanges (12 & 13).
Place a new grinding wheel with specified size. Fit supplied adaptor first if the wheel bore size is 32mm.
Place the outer flange against the grinding wheel and place the nut onto the spindle.
Securely tighten the nut.
Replace the wheel guard.
Always unplug the tool before replacing a grinding wheel.
Never use a cracked grinding wheel. Immediately replace a cracked grinding wheel.
A cracked grinding wheel may break into pieces when used and cause accidents.
Mounting and adjusting the spark guards (fig. A)
You must regularly adjust the spark guard in order to compensate the wear of the grinding wheel.
Mount the spark guard (4) to the wheel guard (3) using the screw (9) (refer to the figure).
Adjust the distance between the spark guard and the grinding wheel (2) to the smallest possible value, with
a maximum of 2 mm.
Tighten the spark guard screw.
Slide the screen (5) to the front.
Tighten the nut (10).
The spark guard protects your eyes and hands from sparks flying from the work piece.
Therefore, always use the spark guard.
Adjusting the work piece supports (fig. A)
You must regularly adjust the work piece supports in order to compensate the wear of the grinding wheels.
Loosen the adjusting screw (7).
Adjust the distance between the work piece support (6) and the grinding wheel (2) to the smallest possible
value, with a maximum of 2 mm.
Tighten the adjusting screw.
B B ench Grinder MPBBG150 User Manual
Keep your hands and feet away from all opening
OPERATING INSTRUCTION
GB 6