MaxPro MPBBG150 Bedienungsanleitung Seite 5

manufacturer. Just because the accessory can be attached to your power tool, it does not assure safe
operation.
•
The rated speed of the accessory must be at least equal to the maximum speed marked on the
power tool. Accessories running faster than their rated speed can break and fly apart.
• Do not use a damaged accessory. Before each use, check the grinding wheel for chips and cracks. If
the machine or application tool is dropped, inspect for damage or install an undamaged application
tool. After inspecting and installing the application tool, position yourself and bystanders away from
the plane of the rotating application tool and run the power tool at maximum no-load speed for one
minute. Damaged application tools will normally break apart during this test time.
• Use the machine only with the spark guard. Sparks being expelled can injure your eyes or set objects
in the vicinity on fire.
•
When grinding, tilt down the spark guard as far as possible. Sparking occurs when grinding metal.
•
Regularly check the clearance between the workpiece supports as well as the holder of the spark
guard to the grinding wheel, and readjust as required. The clearance to the grinding wheel may not
exceed 2 mm. When the clearance is larger, you are not sufficiently protected against sparking. The
workpiece can be drawn in by the rotational motion of the grinding wheel and lead to injuries.
•
Guide the workpiece only against the switched-on machine and do not switch the machine off until
after having removed the workpiece. The workpiece can move suddenly.
•
Never apply the workpiece laterally against the rotating grinding wheel, and always grind from the
front. The workpiece can be drawn out of your hand through the rotational motion of the grinding
wheel and lead to injuries.
•
Never reach into the running grinding wheel of the machine.This can lead to serious injuries.
•
Do not stop coasting grinding wheels by applying lateral pressure to them. The workpiece can be
drawn out of your hand through the rotational motion of the grinding wheel and lead to injuries.
•
Wear a work apron. Pay attention that other persons are not put at risk from sparking. Remove
flammable materials in close vicinity. Sparking occurs when cutting metal.
•
Keep your workplace clean. Blends of materials are particularly dangerous. Dust from light alloys can
burn or explode.
Products sold in GB only: Your product is fitted with an BS 1363/A approved electric plug with internal fuse
(ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its
place by an authorized customer service agent. The replacement plug should have the same fuse rating as
the original plug.
The severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a
mains socket elsewhere.
Products sold in AUS and NZ only: Use a residual current device (RCD) with a rated residual current of 30
mA or less.
5
B B ench Grinder MPBBG150 User Manual
SYMBOLS
Read the manual
Warning
Wear eye protection
Wear ear protection
Wear dust mask
Do not dispose of old appliances in the household garbage
GB