Cleaning And Maintenance; Stainless Steel Surfaces - Gorenje 426150 Gebrauchsanweisung

CLEANING AND MAINTENANCE

Stainless steel surfaces

Printed surfaces
Knob/s
Pan support/s
Burner/s
Do not use a steam cleaning appliance to clean this appliance. The steam could
reach the electrical components and cause a short circuit.
The appliance should be cleaned regularly, preferably after each use, after cooling
•
down.
To avoid water marks and limescale deposits, use a soft cloth to dry surfaces that have
•
been cleaned with water.
Food that has boiled over can cause discolouration of the burner parts and the
•
stainless steel cooktop. Remove any soiling immediately.
To avoid damaging the outer surfaces of your appliance, do not use:
cleaning agents containing soda, alkalines, ammonia, acids or chlorides
•
cleaning agents containing descaling agents
•
stain or rust removers
•
abrasive cleaning agents, e.g. powder cleaners and cream cleaners
•
solvent-based cleaning agents
•
dishwasher cleaner
•
grill and oven cleaners
•
glass cleaning agents
•
hard, abrasive brushes or sponges, e.g. pot scourers, brushes or sponges which have
•
been previously used with abrasive cleaning agents
sharp pointed objects (these can damage the seal between the frame and the
•
worktop).
Clean stainless steel surfaces using a microfibre cloth or with a solution of warm water and a
little washing-up liquid applied with a soft sponge. In the case of stubborn dried-on soiling, soak
first.
Finally, dry with a soft cloth.
The stainless steel cooktop cleaner can be used to clean the frame when required. Apply with an
even pressure following the direction of the "grain".
The care product for stainless steel can be used after cleaning to help keep your appliance
looking good and to hinder resoiling.
Apply sparingly with a soft cloth following the instructions on the packaging.
The printing can be damaged if soiling (e.g. food or fluids that contained salt, olive oil) is
not removed immediately.
Remove any soiling immediately.
Do not use any stainless steel cleaner on printed surfaces. This would rub off the print.
Remove the knob and clean it with a solution of warm water and a little washing-up liquid
applied with a soft sponge. Stubborn soiling should be soaked first.
After cleaning, dry all surfaces with a clean cloth.
Remove the pan support and clean it with a solution of warm water and a little washing-
up liquid applied with a soft sponge. Stubborn soiling should be soaked first and then any
soiling can be removed using a soft brush.
After cleaning, let it dry completely.
Do not clean the pan support in a dishwasher.
The burner should be dismantled and then cleaned by hand using a solution of warm
water and a little washing-up liquid applied with a soft sponge.
Parts of the burner that cannot be removed should be wiped clean with a damp cloth
only.
The ignition candle and the candle flame failure device should be very carefully wiped
clean using a well wrung out cloth.
Do not let the ignitor get wet. If it gets wet, it will not spark.
After cleaning, dry all surfaces with a clean cloth.
Make sure that the flame slits are clean and completely dry.
The surface of the burner crown cover will become more matt with time. This is quite
normal and will not affect the operation of the cooktop.
Do not clean any parts of the burner in a dishwasher.
12