poolstar Coyote Bedienungsanleitung Seite 15

d. Power off the cleaner after use.
e. It is necessary to stay on the water surface for 10-15 seconds until water flows out from the cleaner to
the pool before being placed on the ground.
f. Lift the handle or clips of the cleaner out from the pool.
2. Quick operation
a. Connect the cleaner and home power with adapter and charging line to charge the battery.
* Clean the charging port before charging.
* Red charging indicator light indicates the battery is charging.
* Green charging indicator light indicates charging is finished.
* Turn the switch knob to OFF before charging.
b. Turn the switch knob to ON after putting it into water then the cleaner is power-on and the indicator light
is steady blue. The cleaner begins to work about 15 seconds later while the blue light flashes.
c. The robot reverse direction automatically once touching the pool wall (or rise up-ahead and reverse for
pools with curved floor), and blue light flashes, then the indicator light turns into green for a few seconds
for self-adaption, after that the indicator turns into blue again.
d. After completing its working cycle, the cleaner continues running about 2 minutes to pull over to pool
edge, then it runs into standby mode and the indicator light is steady red.
e. Power-off operation: switch off the knob into red light till the robot power-off.
Please always clean the filter tray after use.
Indicator light
Red light
Green light
Indicator light
Blue light flashing
Red light
Red light flashing
ON OFF
Battery Status
Charging
Full
Working Status
Running
One cleaning cycle finished
Working fault
EN
15