MSI H61I-E35 V2/W8 Serie Bedienungsanleitung Seite 27

tWr
Minimum time interval between end of write data burst and the start of a pre-
charge command. Allows sense amplifiers to restore data to cells.
tWtr
Minimum time interval between the end of write data burst and the start of a
column-read command. It allows I/o gating to overdrive sense amplifiers before
read command starts.
trrd
Specifies the active-to-active delay of different banks.
trtp
time interval between a read and a precharge command.
tFAW
this item is used to set the tFAW (four activate window delay) timing.
tWCL
this item is used to set the tWCL (Write CAS Latency) timing.
tCkE
this item is used to set the tCkE timing.
trtL
this item is used to set the trtL timing.
Advanced Channel / 2 timing Configuration
press <Enter> to enter the sub-menu. And you can set the advanced memory
timing for each channel.
Memory Fast Boot
this item is used to enable/disable Memory Fast Boot.
Gt overClocking
this item allows you to enable/ disable the overclocking of integrated graphics.
Gt ratio
this setting controls the ratio of integrated graphics frequency to enable the inte-
grated graphics to run at different frequency combinations.
Adjusted Gt Frequency
It shows the adjusted integrated graphics frequency. read-only.
Spread Spectrum
When the mainboard's clock generator pulses, the extreme values (spikes) of the
pulses create EMI (Electromagnetic Interference). the Spread Spectrum function
reduces the EMI generated by modulating the pulses so that the spikes of the
pulses are reduced to flatter curves.
IMportANt
* If you do not have any EMI problem, leave the setting at [disabled] for optimal
system stability and performance. But if you are plagued by EMI, select the
value of Spread Spectrum for EMI reduction.
MS-7677
27