Maintenance Instructions - Desoutter E-LIT BOX V2 Bedienungsanleitung

6159920990_03
Rehit yellow
Reverse yellow
Module status
Power green
Activity blue
Tool status
Maintenance yellow
Locked yellow
Ready green

MAINTENANCE INSTRUCTIONS

Maintenance should be performed by qualified
personnel only.
● Prior to any maintenance task:
- disconnect the tool.
- check that the module is switched off.
- disconnect the cable.
Trouble-shooting
Description Solution
The tool does not ● Check the tool is
start when the
trigger is pressed.
● Send a "Unlock"
● Send a "Reset batch"
The tool does not
● Run the "Tool pairing"
send the tightening
reports
● Restore factory default
The tool does not
communicate
The tightening
operation is completed
with a screw rotation
angle lower than
expected.
The run reverse
operation is completed.
The 24 V power supply
is on
The LED is on
each time the tool
communicates to the
module and vice-versa.
The tool cycle counter
has exceeded the
maintenance threshold.
The tool is locked.
The counter batch
has been successfully
reset.
The tool is ready to
start.
communicating with the
E-LIT BOX V2 module.
command.
command.
procedure.
on E-LIT BOX V2
module and then run
the "Tool pairing"
procedure.
Spare parts
Description
Antenna
Connections kit
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
According to Directive 2012/19/
CE concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
● Contact your Desoutter
representative or consult the website
"www. desouttertools.com" to find out
where you can recycle this product.
12 / 40
English
Part number Qty
6159270505 1
6159281150 1
11/2017
Wear
X
X