Desoutter E-LIT BOX V2 Bedienungsanleitung Seite 11

English
Advanced settings update
● Launch "E-LIT PC" software to set the
advanced settings.
- channel of communication between the tool
and the module
- anti-theft level
- transmission power level
- acknowledgement output signal from the PLC
- modification of the input assigments
● Keep pressing IN1, IN2, IN3, IN4
and switch on the power switch
to reset the advanced settings to
factory default.
● For more information, refer to
the user manual of E-LIT PC
software at http://resource-center.
desouttertools.com.
Power level and permitted channels setup
1. Connect Elitbox to your computer.
2. Run ElitPC software.
3. Declare your ElitBox as a new access point (if
not already done).
4. Get access to your ElitBox settings by clicking
on " " button.
5. Adjust "Transmit Power" in Credentials tab,
6. Select permitted "Channels" in "Wireless
network" tab.
7. Stop network using "Stop" button.
8. Start network using "Start" button.
Now your ElitBox has re-started network
management.
On starting network, if multiple channels have
been selected, 1st free one (no activity) to be
automatically used.
Selected channel value is displayed into status
bar after "NW" comment.
11/2017
Tool pairing
Important! for tools previously paired,
please repeat tool pairing procedure.
● Switch off the power switch.
● Select how to pair the tool:
- E-LIT BOX simulator
● Activate inputs IN1 and IN2 by
pressing BP1 and BP2 buttons on the
simulator.
● Switch on the power switch.
● Keep inputs IN1 and IN2 activated
by keeping BP1 and BP2 buttons
pressed until the LED "Maintenance"
starts blinking.
- "Tool pairing" button
When the LED "Maintenance" starts blinking, the
E-LIT BOX V2 accepts a new tool during the next
60 seconds.
The tool previously married is
automatically cleared.
● Refer to the complete procedure
"Network connection" described
in the tool user manual.at http://
resource-center.desouttertools.com.
G
LEDS COLOR CODE
● See page 8.
Report status
OK
NOK
Batch OK
11 / 40
6159920990_03
● Keep pressing the "tool
pairing" button and put the
power switch on.
green The tightening
operation is correct.
red The tightening
operation is rejected.
blue The tool has
successfully completed
"n" correct tightening
operations.