Motostar MP100 Installationsanleitung Seite 30

F50
Do not modify. Function unavailable.
F51
Do not modify. Function unavailable.
U1 Entering a user
Entering up to up to a 25 users maximum and associating to each one a function chosen among the existing ones. This must be done via
transmitter or other control device (see "ENTERING USERS WITH ASSOCIATED COMMAND paragraph).
U2 Deleting a user
Deleting a single user
U3 Deleting users
Deleting all users.
A1 Type of motor
Select 6 to confi gure the gearmotor's control board.
A2 Motors test
Test for checking the gearmotors' proper rotating directions (see the MOTORS TEST paragraph).
A3 Auto-learning of gate travel
Automatic learning of the gate travel (see paragraph on AUTO-LEARNING OF THE GATE TRAVEL).
 This function appears only is the Encoder function is activated.
A4 Resetting parameters
Warning! The default settings are restored and auto-learning of the gate travel is cancelled.
H1 Version
View the fi rmware version.
1= Step-step command (open-close) / 2= Sequential command (open-stop-close-stop)
/ 3= Open only command / 4= Pedestrian/ partial / command 5= Do not use
0= Deactivated / 1= Deleting all users
1= (default) / 2= do not use / 3= do not use / 4= do not use / 5= do not use /
6=MP100 / 7= do not use
0= Deactivated / 1= Activated
0= Deactivated / 1= Activated
0= Deactivated / 1= Activated