Steering System; Pedal Operation - Yamaha YDRE Serie Benutzer-/Betriebsanleitung

PRE-OPERATION CHECKS
1
2
3
4
5
DEATH OR SEVERE PERSONAL INJURY CAN RESULT FROM FAILURE TO FOLLOW THESE INSTRUCTIONS.
• Read the label located on the steering wheel before operation.
• Operate only when authorized and only in designated areas.
• Operate from driver's side only.
• Do not allow more than two occupants per seat.
• Do not start vehicle until all occupants are seated.
• Remain seated and hold on when in motion.
• Keep entire body inside vehicle.
• Drive slowly in turns.
6
YAMAHA
7
8
9
10
11
5-3
Y-932a
• Drive slowly straight up and down slopes.
• Set parking brake before leaving vehicle.
• Turn main switch to "OFF" and remove key when not in use.
• Do not operate while under the influence of alcohol or drugs.
JC1-K7768-00
Y-2275
Y-20A

STEERING SYSTEM

Check the steering system for
excessive freeplay by:
moving the steering wheel up and
G
down, and back and forth.
turning the steering wheel slightly
G
to the right and left.
If you feel excessive freeplay, or
hear rattling sounds which may
indicate loose steering components,
consult a Yamaha dealer.
REVERSE ALARM
Check the reverse alarm by moving
the drive select switch to "REV" for
reverse. The alarm should sound.

PEDAL OPERATION

Check the following pedal controls
for proper operation. If a pedal does
not work properly, consult a Yamaha
dealer.
Accelerator Pedal
With the main switch in the "OFF"
position, make sure the accelerator
pedal operates smoothly.
å Accelerator pedal
JC1