Replacing The Oil Filter; Coolant - PEUGEOT CityStar Serie Bedienungsanleitung

NOTICE_CTS_EURO4_V3-04A.mif Page 20 Lundi, 6. mars 2017 10:27 10
CITYSTAR 125 cc Official type-approval code:
H4ABBA - H4ABBB
CITYSTAR 200 cc
FR
We advise you to go to a registered
dealer for draining.
GB
Oil contains substances which are
harmful to the environment. Your dealer
is equipped to dispose of used oil
without endangering the environment
DE
and in compliance
standards.
IT
125 cc
Official type-approval
SAE 5W40 Synthetic API
code: H4ABBA -
H4ABBB
ES
200 cc
Quantity 1 l at oïl change
NL
The engine must be drained when it is warm to allow the
oil to run easier.
• Park the vehicle on its stand.
GR
• Put on protective gloves.
• Remove the cap/oil gauge.
• Remove the drainage cap and its seal (2) and allow the
oil to drip into a recipient.
SE
• Clean the strainer.
PT
FI
2
DK
20/25
• Insert the drain plug fitted with a new seal.
• Pour the required quantity of oil corresponding to the
manufacturer's standards into the filler hole
• Fit the cap/oil gauge.
• Start the engine and let it run for a short while.
• Check and adjust the oil level if necessary.
• Check that the oil drain plug is sealed.

REPLACING THE OIL FILTER

CITYSTAR 125 cc Official type-approval code:
with current
H4ABBA - H4ABBB
CITYSTAR 200 cc
We advise you to go to a registered
dealer for draining.
SL/SJ
Oil contains substances which are
harmful to the environment. Your dealer
is equipped to dispose of used oil
without endangering the environment
and in compliance with current
standards.
The oil filter must be changed each time the oil is
changed.
• Remove the bottom panel (Left side).
• Remove the filter cover (3).
• Replace the filter element (4).
• Oil the seal slightly.
• Install a new oil filter and its cover.
4
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters

COOLANT

CITYSTAR 125/200 cc
• Place the vehicle on its central stand on flat ground.
• Check the coolant level through the oil-contect window.
MAX
MIN
The right headlight fairing must be removed to top up via
the expansion tank cap.
3
The coolant level must be cold checked
regularly and topped up only with coolant
recommended by the manufacturer.